Installation guide

Before You Begin (Standard)
2-2 AcceleRAID 150 Installation Guide
Before You Begin (Standard)
Installing a standard AcceleRAID 150 PCI to Ultra2 SCSI RAID controller
board is no more difficult than installing any PCI adapter board. Follow
these steps and then follow the installation procedures in this chapter.
Occasionally, you may need to refer to the instructions that came with your
computer system.
, WARNING
Power OFF the system and disconnect the power
cord from the electrical wall outlet before opening
the system cabinet. Working with the system
covers off and power applied to the system can
result in shock and serious injury.
, WARNING
This controller board is furnished with a
nonvolatile RAM (NVRAM) chip that uses a sealed
lithium battery/crystal module. Replace the
module only with the same or equivalent type
recommended by the manufacturer.
Dispose of the used battery/crystal module
according to the manufacturer’s instructions.
Never incinerate a battery as it could explode and
cause serious injury.