Installation guide

Controller Start-up
3-2 AcceleRAID 170 Installation Guide
Controller Start-up
The controller start-up procedure is the first step in confirming that the
controller is correctly installed and working properly. The start-up procedure
should be performed prior to any software configuration. There are two start-
up sequences:
• BIOS Options sequence, and
• BIOS Configuration Utility sequence
Either start-up sequence can be skipped by ignoring the
<ALT-M> and/or the
<ALT-R> prompt when the computer is powered on.
BIOS Options Sequence
After physically installing the controller and connecting the cabling, do the
following steps if you need to set or modify a BIOS option, see “Setting
BIOS Options” on page 3-3 for details:
1. Power on the computer.
2. Watch the messages on the screen for the following prompt to be
displayed:
Press <ALT-M> for BIOS options
3. Press Alt–M to get into the BIOS Options menu.
4. The BIOS Options menu provides the following items to choose from:
5. To select any of the items in the menu, highlight the selection with the
Up Arrow or Down Arrow. Press Enter to toggle any of the three
items.
Note
BIOS must be enabled to toggle the CD-ROM boot
option.