Installation Guide

14 www.mylenstairs.com
Platform Installation
1. Screw the threaded rod (27) into the nut in the column. The threaded rod
should protrude approximately 6” up past the top of the column segment.
2. Slide the spacers (5) (if needed) centering rings (4) and sleeve onto the
column segment. Use the same number of spacers as the tread below.
Do not install the platform unless the stair is braced. The
weight of the platform could cause the stair to become
unstable. Failure to brace the stair could result in serious injury
or death.
3. Slide the platform (11) over the column. Temporarily hold the platform in
position on the surface it will be mounted to.
4. Check that the platform is level while holding it in position. If it is not level,
add or remove spacers below the platform to bring it to level.
Hardware
ⒶⒷⒸⒹ
ⒺⒻⒼⒽ
Parts
③④⑤⑪
⑫⑬⑭ 27
Tools