Installation Guide

Pioneer Business Park, Faraday Way, Stallingborough, DN41 8FF | 03 33300 1303 | www.myenergi.com
myenergi Ltd. | Registration No. 10261262 June 2022, Revision 1.2
D3470
Suitable 10mm Fixings (To be
determined by installer based on
substrate depth etc.)
For fixing base plate to concrete
substrate.
4mm Allen Key/Hex Key
For mounting of the
zappi
EV charging
station.
Cabling tools
For making all connections
General tools, drill etc.
For mounting of the pedestal.
7.2 Location requirements
b If pedestal is installed in close proximity of a road or public parking place an
adequate collision barrier/guard/protector must be installed.
b Should you install more than one pedestal in the same location you should
ensure there is at least a 200mm gap between the two.
b The surface you are mounting to should be fully level and flat.
7.3 Mounting base
It is the responsibility of the installer to ensure the base for mounting the stand is of
a suitable build up and thickness and the fixings used to secure the pedestal are
adequate enough for the substrate you are mounting to.
General;
b The electrical supply cables must come out of the concrete at the centre of the
pedestal’s baseplate and have an excess of at least 1500mm
7.4 Step by step instructions
These instructions are for the installation of the pedestal only and should be read in
conjunction with the zappi operation and installation manual.
Step 1: Remove from box and recycle packaging.
Step 2: Remove rubber grommet as necessary on side you will be mounting your
zappi(s) and slice down the centre line to create an opening.
Step 3: Feed cable through the base plate and up the pedestal to the hole and through
the grommet.