User Manual

vHub & WiFi Module Operation Manual
Rev 01 FEBRUARY 2022
3
8. Wait 5 seconds for your password to change and the webpage to reload.
9. Once connected, you will be directed to a webpage where you will need to select your home WiFi Network (from
the list in the “Detected Networks” box) and type in your WiFi password to connect to your router.
NOTE: In most cases you should leave the “Use DHCP” option ticked.
However, if you want to give your zappi/eddi a fixed IP address then untick
the ‘Use DHCP’ box and fill in the extra information needed.
10. Please wait 15 seconds for the connection to take place.
11. Finally, make sure that the WiFi is connected. You can check this by either:
a. Looking on the settings web page, where you should see “Connected” is showing as “True” or
b. On the WiFi screen on the zappi, where it should show as “Connected”
NOTE: If the screen above does not appear check your phone or computer is still connected to the
myenergi access point.
12. You can now turn the ‘Access Point’ OFF as it’s only needed to set up the WiFi connection. Turning it off
prevents anyone else connecting to the zappi WiFi.
To do this go to your zappi menu:
13. Navigate to ‘Other Settings’ > ‘Internet’ >’WiFi’ > ‘WiFi Config…’
14. Scroll down to ‘Access Point’, and press ‘+’ to set to OFF