User Manual
Table Of Contents
- 1. Introduction
- 2. Safety
- 3. Disposal
- 4. Copyright
- 5. Overview
- 7. Operation
- 8. Display
- 9. Operating Modes
- 10. Manual Boost
- 11. Boost Timer
- 12. Configuration Settings
- 13. Advanced Settings
- 14 Linked Devices
- 15 Fault Codes
- 16 Warranty
- 17 Product Registration / myaccount
- 19. Technical Support
- 20. Declaration of Conformity
Page 8 of 24
7. Operation
7.1 Controls & Indicators
1.
Display
Graphical LCD display with LED backlight
2.
Power ‘ON’
Indicator
Illuminates when:
Unit is connected to the mains supply and;
The ON/OFF and BYPASS switch is in the ON position (I)
3.
Control Buttons
Four tactile buttons to navigate the menus and alter settings:
Enter menu (from main screen) | Exit current menu
Move up a menu item | Increase value
Move down a menu item | Decrease value
Boost | Select item | Confirm value and move to next setting
4.
Heater Output
Indicators (1 & 2)
Illuminates when the respective heater output (1 or 2) is active. The brightness
will vary with the output voltage. If both 1 & 2 are lit together, both heaters are
at maximum temperature.
5.
ON/OFF and
BYPASS Switch
This switch has three positions:
I ON – eddi is on (This is the normal position)
0 OFF – eddi is off (The power on indicator will be off)
II BYPASS – eddi is bypassed; the mains supply is directly connected to
the Heater 1 output. In this position the Power indicator will be off and the
Heater 1 indicator will be illuminated.