User manual

Visionari Limited Liability Company Visionari Copyright(1.4)2010Version
http://www.mydepots.com
42
8308R Series Network DVR User Manual
Input the user name and password that ISP（Internet service provider）provides. After saving it reboot up
your system. Then the DVR will build a network connection based on PPPoE. The IP address will change into
dynamic IP address after above operation is well done.
Operation：After PPPoE dialing successfully look up the IP address in the [IP address] and obtain the current
IP address. Then use this IP address to visit the DVR through user port.
【NTP setup】
Picture4.19 NTP setup
The NTP server must be installed in the PC.
Host computer IP：Input the IP address installed NTP server.
Port：Default: 123. You can set the port according to NTP server.
Time zone：London GMT+0 Berlin GMT +1 Cairo GMT +2 Moscow GMT +3 New Delhi GMT +5
Bangkok GMT +7 Hongkong Beijing GMT +8 Tokyo GMT +9 Sydney GMT +10 Hawaii GMT-10
Alaska GMT-9 Pacific time GMT-8 American mountain time GMT-7 American mid time GMT-6
American eastern time GMT-5 Atlantic time GMT-4 Brazil GMT-3 Atlantic mid time GMT-2.
Update cycle：The same with the NTP server check interval. Default: 10minutes.
【EMAIL setup】
If the alarm is turned on or the alarm linkage photos are taken, send an email about the alarm information and
the photos to appointed address.