Owner Manual

Anchoring Instructions (Only for safes with pre-drilled anchor holes)
Notice : Anchor bolt must be inserted into oor BEFORE safe is bolted down.
1. Anchor bolts vary according to model. After checking anchor bolt size, drill a hole to a
depth of 2 inches (50mm). Refer to chart for appropriate hole size.
2. Insert anchor bolt and pipe into hole.
3. Place at washer and nut on anchor bolt. Tighten with 14mm wrench to allow anchor
bolt to expand and secure into oor.
4. Remove nut and washer from anchor bolt.
5. Place safe on top of anchoring bolt through center hole on bottom of safe.
6. Place washer, lock washer, and nut on anchor bolt. Tighten
A(Anchor size) B(Diameter of hole)
1/4"(M6×50mm) Ø10(5/16")
3/8"(M10×101mm) Ø14(9/16")
3/8"(M10×152mm) Ø14(9/16")
Notice : 1. Bolt may need to be cut.
2. Place cover over hole for re resistance.