Owner Manual

There are eight (8) points of contact to secure your
MyCube. Four (4) points on the bottom, and four (4)
points on the back of each safe. When the safe is in
the desired position, take a marker and through the
pre-drilled holes inside the safe, mark the surface(s)
on which you will be securing the screws.
Remove the safe and use a power drill and drill into
each mark to make holes for the provided screws.
Put the safe back in position, and line up each hole
in the safe over each of the drilled points. Place
each of the provided washers over each hole inside
the safe, and with a screwdriver or right-angle
power drill, secure each screw into the surface.
INSTALLATION
11