User Manual

• Temperatures above +32 °C may see a slight
performance drop.
• When using the unit ensure the circuit being used
has a fuse or circuit breaker, recommended size
for DC 12 Volt is 10 Amp, DC 24 Volt is 5 Amp.
• Make sure the voltage is within the correct
range for socket and cable being used.
• Do not place any electrical devices inside
the appliance as they may be damaged.
• Your unit requires good ventilation, especially
around the vents of the appliance; allow a
gap of at least 100 mm around all vents.
• Do not allow a large amount of frost to
build up on the inside walls as this may
impair cooling.
• Designed for short term warming and
cooling.
• Defrost by turning the unit o , allowing
the frost to melt and wipe out the water.
Problem Possible Cause Possible Solution
Cooler
is not
heating
or
cooling
• No voltage available at DC socket
• Poor or dirty connection at DC socket
• Break in connection cable from
DC socket from appliance
• Fuse in DC connection cable has blown
(open circuit)
• Vehicle fuse blown (open circuit)
• Ignition not on
• Appliance is not on
• Check vehicle fuse is not blown (open circuit)
• Visually check the DC socket contact surfaces for
contamination or oxidation
• Visually inspect the DC cable for damage. If damage
is sighted, dispose of cable and purchase a new one.
• There is a fuse located in the tip of the DC plug. Visually check
to see if the fuse has blown. If the fuse has blown, replace.
• Visually inspect your vehicles fuse and replace if blown.
• Check that the ignition is turned on
• Check that the appliance is switched to either the HOT or COLD.
Turning the unit on and off :
Step 1: Plug in the DC power cable (ensure power is on at source).
Step 2: Slide the switch from the OFF middle position to either the
HOT or COLD setting.
Important Product Information
Control Panel & Operation Instructions
Troubleshooting
page 3
NOTE:
• The light will illuminate
next to the mode that is
engaged.
• A GREEN light will
illuminate next to COLD
to indicate that it is
working and cooling.
• A RED light will illuminate
next to HOT to indicate
that it is working and
warming.
CTP10 COOLER·WARMER
Power Switch
USB Socket
Indicator Light COLD
Indicator Light HOT DC Input Socket