Installation & Assembly

STEP 1
NOTE : MUST TIGHTEN SCREWS PERIODCALLY WITH USE SCREW WILL BECOME LOOSE CHECK TIGHTNESS OF ALL SCREW EVERY 6-8 WEEKS.
STEP 2 :
STEP 3 :
B
A
C
2
3
5
4
Note : Make sure arrow marking of the mirror support is
aligned with the arrow marking of the center of the
dresser as show in drawing.
NO
ITEM
Qty
A
MIRROR
1 PC
B
MIRROR SUPPORT RAIL
2 PCS
(Box 1)
BOX OF MIRROR
NO
ITEM
Qty
C
DRESSER
1 PC
NO ITEM
Qty
1
JCBC BOLT M6 x 35MM BLK
4 PCS
2
JCBC BOLT M6 x 40MM BLK
4 PCS
3
SPRING WASHER 1/4" RBW
8 PCS
4
FLAT WASHER 1/4" ID x 19mmOD
BLK
8 PCS
5
ALLEN KEY m4 x 65mm BLK
1 PC
MODEL : 0138A
DRESSER & MIRROR
B
ARROW MARKING - UP
A
**BACK VIEW
ARROW MARKING - UP
B
1
3
4
5
A
(Box. 2)
BOX OF DRESSER
(Box. 1)
HARDWARE LIST
**HARDWARE SET IS IN 1857-6 FOR ASSEMBLY
ASSEMBLY INSTRUCTION
WARNING !
Use Short Bolt
M6 x 35mm
WARNING !
Use Long Bolt
M6 x 40mm
COMPLETED ASSEMBLY
Draw out mirror support (B) from the carton box.
Place mirror (A) on top of dresser (C). Align & fasten mirror support (B) to
the back of dresser (C) using long JCBC bolt (2) , spring washer (3) & flat
washer (4) THEN FULLY TIGHTEN ALL THE BOLTS AT STEP 2 & 3
WITH ALLEN KEY ( 5).
Align & fasten mirror support (B) to the back of mirror (A) using short JCBC
bolt(1),spring washer (3) & flat washer (4). DO NOT FULLY TIGHTEN AT THIS
STEP.
Note : Make sure arrow marking of the mirror support (B) is aligned up.