Manual

4 5
Thanks for choosing myCharge.
In The Box
• myChargePeak
• Owner’sManual
• WarrantyManual
Section I: Quick Start
1. Charge up your Peak in one of two ways: use the fold-out
prongs on the back of the unit for fast-charging via wall
outlet or extend the USB charging cable located on the
 sideoftheunittoplugintoyourlaptop’sUSBport.
2. As Peak charges, LEDs on the unit will sequentially
 illuminate.Whentheunitisfullycharged,allLEDsare
lit. Press the level check button to see how much power is
available.
3. Peak comes equipped with Apple and Micro-USB
connectors, as well as a built-in USB port for use with your
own cable. Connect your device(s) to one of the various
inputs available. If your device doesn't begin charging
automatically through the USB port, power the Peak
off and on again. Charge up to three devices
simultaneously by using all connectors and USB port.
4. Unplug your device when it's charged and go! Your
Peak will automatically power off after your devices are
unplugged.
Section II: Charging Peak
The fastest way to charge Peak is via the fold-out wall
prongs–simplyplugitintoawalloutlet.Whenyouare
awayfromanoutlet,connectPeaktoyourcomputer’sUSB
port and charge via the on-board green USB input cable.
TimestochargethePeakvarybasedonwhatit’splugged
into. You can expect a full charge from the wall in about
four hours or from a standard notebook USB port in about
thirteen hours.
Note: It is normal for your Peak to be warm to the touch
while in use.
USB Charging
Cable
Apple 30-pin
Connector
Micro-USB
Connector
USB Port
LEDs
Multifunction
Button
WallProngs
Charge from the wall or your computer