Instructions / Assembly
IAPMO RESEARCH AND TESTING, INC.
CERTIFICATE OF LISTING
Issued To: KAIPING YIZHAN VALVE CORE CO., LTD. Eective Date: October 2019
File Number: MC-7195 Revised Date: October 21, 2022
Product: Plumbing Fixture
Fittings*Materials/Components*
Void After: October 2024
This certicate is not evidence of current listing.To verify listing status, visit the IAPMO R&T Product Listing Directory at pld.iapmo.org
Identification:
Plumbing supply fittings components shall be marked with the manufacturer's recognized name, trademark, or other mark or, in
the case of private labeling, the name, trademark or other mark of the customer for whom the fitting was manufactured. The
marking shall be accomplished by use of a permanent mark or by placing a permanent label on the product. Markings on
plumbing supply fittings components shall be visible after installation.
Showerheads and hand-held showers shall be marked with the manufacturer’s specified maximum flow rate, in L/min and gpm
Kitchen, lavatory, and metering faucets shall be marked with the manufacturer’s specified maximum flow rate, in L/min and gpm
or L/cycle and gpc.
Single-handle and single-control bath and shower mixing valves shall have their temperature control settings identified
alphabetically, numerically, or graphically
High-efficiency commercial pre-rinse spray valves shall be marked with the manufacturer’s specified maximum flow rate, in
L/min (gpm).
Listed products or packaging shall bear the cUPC® certification mark with "COMPONENT" above.
Packaging for plumbing supply fittings shall be marked with the manufacturer's name, trademark, or other mark as well as the
model number or, in the case of private labeling, the name, trademark, or mark of the customer for whom the fitting was
manufactured as well as the model number.
Packaging for showerheads and hand-held showers shall be marked with the manufacturer’s specified maximum flow rate and
either the manufacturer’s specified minimum flow rate or the statement “For use with automatic compensating valves rated at
xxx L/min (yyy gpm) or less”, where xxx L/min (yyy gpm) is the manufacturer’s specified minimum flow rate.
Packaging for kitchen, lavatory, and metering faucets shall be marked with the manufacturer’s specified maximum flow rate, in
L/min and gpm or L/cycle and gpc.
Characteristics:
Plumbing fixture fitting components to be installed in accordance with the manufacturer's instructions and the requirements of
the latest edition of the Uniform Plumbing Code and National Plumbing Code of Canada.
Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory. This recognition has been granted
based upon the laboratory's compliance to the applicable requirements of ISO/IEC 17025.
Page 2 of 5