Service manual

24
22. Check Mode
1. Staple Unit Check Mode
- Turn on power with eject button pressed.
- Every time eject button is pressed, staple works.
- Lock sensor works during check mode. If staple lock continues for more than 1 second,
staple motor stops and staple trouble lamp on monitor flashes
2. Punch Unit Check Mode
- Turn on power with eject button pressed.
- Press staple mode switch to select "corner staple 0˚".
- Every time eject button is pressed, punch works.
NOTE
- Operate punch unit with 3 to 4 seconds intervals. Otherwise, motor or controller may be
broken. Lock sensor works during check mode. If punch lock continues for more than 2
seconds, punch motor stops and punch trouble lamp on monitor flashes.
3. Check on Complete Functions
- Turn on power with staple mode button and eject button pressed at the same time. And
complete function of PS-P61 will work successively except punch.
NOTE
- Operating PS-P61 with staple cartridge in check mode may cause staple jam. When
operating in check mode, remove staple cartridge or insert sheets into staple section.
- When each of monitor lamp flashes, PS-P61 does not work. Turn off power and turn on
again.
- Check mode does not reset until power is turned off. Turn on again when collating job is
started.