User manual

Technische Beschreibung
/ technical description myAVR Board MK3 3.10
Seite: 13/22
www.myAVR.de © Laser & Co. Solutions GmbH - 07/2009 www.myAVR.com
Programmereinstellungen
Programmer settings
Programmereinstellungen SiSy AVR (ab 2.18b)
changing setting in SiSy AVR (ex 2.18b)
Versetzen Sie den USB-Programmer mySmartUSB MK3
in den Modus myMode (näheres dazu, finden Sie im Ab-
schnitt zur Tochterplatine mySmartUSB MK3, sowie der
Technischen Beschreibung zum mySmartUSB MK3).
Starten Sie SiSy und legen Sie ein neues Projekt an. Im
Programmfenster von SiSy klicken Sie das Symbol „klei-
nes Programm“ mit der rechten Maustaste an und wählen
„Definieren...“. Im sich öffnenden Fenster entfernen Sie
das Häkchen „Vorgabe benutzen“ und klicken auf Hard-
ware einstellen.
Im myAVR ProgTool wählen Sie den USB Programmer
mySmartUSB MK3 und klicken auf Test.
SiSy übernimmt die Taktfrequenz, den verwendeten
Controller und den COM-Port. Klicken Sie auf den erkann-
ten Controller und anschließend auf Speichern.
Für das Beispiel wurde das myAVR Board MK3 256 ver-
wendet.
Put the mySmartUSB MK3 into the myMode compatibility
modus (you find more informations to that, in the section
of the mySmartUSB MK3 and in the technical description
of the mySmartUSB MK3).
Open an project or create a new one. To adjust the hard-
ware, choosing right click on the project and "Definieren
...". Remove the checkmark "Vorgabe benutzen" and click
on Hardware einstellen.
Adjusts via myAVR ProgTool the mySmartUSB MK3 Pro-
grammer and click on Test button.
SiSy get, the used controller, the COM port and the
frequency. Now you click on the recognized controller and
after that, on the Speichern button.
In the example was used the myAVR Stamp 256 PLUS
with an ATmega2650.
?
Status-LEDs
status-LEDs
Prog-Mode:
abhängig vom Zielsystem
prog-mode:
depending on target system
Mode-Taster
mode-button
Auswahl:
Taster kurz tippen
Choise:
press button short
Mode: myMode
Nach dem Speichern öffnet sich ein Informationsfenster
welches anzeigt, dass die Einstellungen übernommen
wurden.
An information window opens, after you haved used the
Speichern button and confirm, that the attitudes were
taken on.