Owner`s manual

Page 25
 Press 0 (OFF) to turn the selected room off (all lighting loads in the room are turned off).
 Press 1 (ON) to turn the selected room on (all lighting loads in the room are turned on).
 Press 2 (A) to set all of the lighting loads in the selected room to their preset levels for Scene A.
 Press 3 (B) to set all of the lighting loads in the selected room to their preset levels for Scene B.
 Press 4 (C) to set all of the lighting loads in the selected room to their preset levels for Scene C.
 Press 5 (D) to set all of the lighting loads in the selected room to their preset levels for Scene D.
 6 (SET) is not used with Vizia RF Z-Wave lighting.
 Press # (STA) to view the current status of the room.
Controlling Individual Lighting Loads in an Vizia RF Z-Wave Room
To control individual lighting loads in a room, use the down arrow key to scroll through the list of units. When the unit is
displayed, press the ' # ' key. For Vizia RF Z-Wave lighting loads, the console will display:
LR Sconce
0=OFF 1=ON 2=DIM 3=BRT
↓
LR Sconce
4=LVL 5=RMP 9=TIM #=STA
↑
 Press 0 (OFF) to turn the selected lighting load off.
 Press 1 (ON) to turn the selected lighting load on.
 Press 2 (DIM) to dim the selected unit (1-9 steps, each step is 10% from its current level).
 Press 3 (BRT) to brighten the selected unit (1-9 steps, each step is 10% from its current level).
 Press 4 (LVL) to set the desired lighting level of the selected unit (0%-100%).
 5 (RMP) is not used with Vizia RF Z-Wave lighting.
 Press 9 (TIM) to time the selected unit (On, Off, Dim, Brighten).
• Timed commands may be from 1-99 seconds, 1-99 minutes or 1-18 hours.
 Press # (STA) to see the status of the device.
Note: When a Z-Wave signal is received over the network, OmniPro II will automatically update the status of the device.
Controlling CentraLite Units
Entry Lights
0=OFF 1=ON 2=DIM 3=BRT
↓!
Entry Lights
4=LVL 5=RMP 9=TIM #=STA
↑
!
 Press 0 (OFF) to turn the selected unit off.
 Press 1 (ON) to turn the selected unit on.
 2 (DIM) does not affect CentraLite units.
 3 (BRT) does not affect CentraLite units.
 Press 4 (LVL) to set the desired lighting level of the selected unit (0%-100%).
 5 (RMP) does not affect CentraLite units.
 Press 9 (TIM) to time the selected unit (On or Off). Timed commands may be from 1-99 seconds, 1-99 minutes or 1-18
hours.
 Press # (STA) to see the status (On or Off) of a CentraLite device.
WEB VERSION