Owner`s manual

d. Thermostats: current temperature, heat setpoint, cool setpoint, heater currently running, air conditioning
currently running, system mode, fan mode, hold mode, freeze alarm, communications error, current humidity,
humidify setpoint, dehumidify setpoint, currently humidifying, currently dehumidifying, and outdoor
temperature.
e. Temperature Sensors: current temperature, low setpoint, high setpoint, freeze alarm, and output state.
f. Humidity Sensors: current humidity, low setpoint, and high setpoint.
g. Time: time (hour and minute), hour, minute, daylight saving time status, and time of sunrise and sunset.
h. Date: date (month and day), year, month, day, and day of week.
i. Audio: power state, source, volume, and mute status for each audio zone.
j. Access Control: lock status, last user, and whether access was granted or denied for each access control reader.
k. Messages: currently displayed message and if it has been acknowledged.
l. System: current energy cost, phone line status, battery reading, ok to arm status, armed status, and outdoor
temperature.
Real-Time Operation Status of Thermostats
The current real-time heating and cooling status on an Omnistat or Omnistat2 is indicated on the Temperature Page on an
OmniTouch Touchscreen. When the HVAC system is currently heating, a yellow block will appear around “Heat”. When the
HVAC system is currently cooling, a yellow block will appear around “Cool”
The current real-time humidifying and dehumidifying status of an Omnistat2 is indicated on the Humidity Page, for the respective
Omnistat2, on the OmniTouch Touchscreen. When the thermostat is calling for humidification, a yellow block will appear
around “Hmfy”. When the thermostat is calling for dehumidification, a yellow block will appear around “Dfhy”.
The current real-time status for heating, cooling, humidifying, and dehumidifying can also be used in automation programming
logic.
Omnistat2 Features
There are several features on Omnistat2 thermostats that are supported by the OmniPro II controller. These features include:
 Fan Cycle Mode
 Vacation Hold
 Humidity Display
 Humidity Setpoints
 Outdoor Temperature
 Occupancy Status
 Time and Date
 Energy Status
Fan Cycle Mode
In Fan Cycle mode on an Omnistat2 thermostat, the fan is cycled on and off in 20 minute cycles to circulate the air.
The fan control may be switched between auto, on, and cycle by selecting 4 (FAN) from the temperature menu of the selected
Omnistat2 thermostat:
Upstairs FAN
0=AUTO 1=ON 2=CYCLE
WEB VERSION