Installation manual

D9124 Operation & Installation Manual
Page 9
© 1995 Radionics
74-06799-000-D 2/95
✱
✱
✱
1234567891011121314151617181920212223242526
D928 DUAL PHONE
LINE SWITCHER
D9142
POWER SUPPLY
D1256 COMMAND CENTER
CUT AWAYS FOR
D192C MODULES
INSTANT
DELAY
TEST
WATCH
SPECIAL
PARTIAL
POLICE
COMMAND
A B C
0
8
9
D
O O O O O O O O O O O O O O
3
2
ALL
1
5
6
7
4
X X X X X X X X X X X X X X X X
POPEX 1
D9124 LTB
Accessory Module Carrier
Maximum 24VDC output on terminals 5, 7 & 9
is 4 Amps.
Maximum 12VDC output on terminal 1 is:
240 mA for single POPEX systems
400 mA for dual POPEX systems.
The D8124G2 system is delivered with a
single D8125 POPEX installed (71points). It
can be expanded with one additional POPEX
for a total of 134 system points.
POPEX 2
CIRCUIT 1 CIRCUIT 2
SILENCE
UP
DOWN
NORMAL
Signaling Circuit
Disable Switches
Signaling circuits must be
terminated with 560 Ω 2 watt
EOL resistors, Radionics
Part Number 15-03130-005.
19 20 21 22 23 24 25 2611 12 13 14 15 16 17 18
CUT AWAY FOR D928
D192C INDICATING CIRCUIT
SUPERVISION MODULES
D8125 POPEX #1 SLOT
(MODULE INSTALLED)
D8125 POPEX #2
SLOT (OPTIONAL)
D192C #1
D192C #2
Figure 2: Modules Installed on Module Carrier
The accessory module carrier also includes a D1256 Fire Command Center. The right
hand side of the carrier's faceplate has three cutaway sections. The one nearest the
D1256 allows you to see the LEDs of the D928; the next two provide you easy access to
the alarm switches on the D192C modules.
The wiring harness is assembled at the factory, and terminal blocks need only be
snapped into place in the designated locations on the D9112LTB.
Literature Pack
The literature package (70-06934-000) shipped with the D9100 consists of:
• D9124 Installation and Operation Manual (74-06799-000)
• D9112 Control/Communicator Program Entry Guide (74-06145-000)
• D9112 Program Record Sheet (74-06100-000)
• D9112 Program Record Training Sheet for the D9124 (74-06802-000)
• D1256 Fire Command Center User’s Guide (71-06991-000)
• Technogram: Smoke Detectors Compatible with the D9112 (73-06143-000)
• Information Booklet on Security Alarm Systems (71-05834-000)
• Vertical Grid for POPEX #1 (79-04252-002-D)
Vertical Grid for POPEX #2 (79-04252-003-D)
Use these labels to mark POPITs installed in the D9124 system. Popit number
programming and address settings are the same for the D9124 System as for the
D9112.
• Point Chart Label (79-06660-000)
Point chart label required for fire systems with verification points: You must
install the point chart label for fire or combined fire/burglary systems using verification
points.
Use the program record sheet to gather the information you need to fill out the point
chart. Install the label inside the enclosure door. To avoid smearing your entries on
the chart, use the label’s peel off backing to press the label in place.