Installation manual
D9124 Operation & Installation Manual
Page 13
© 1995 Radionics
74-06799-000-D 2/95
Installing Battery Shelves and Transformer Cover
Battery and transformer cables route through notches in the
upper battery shelf and the right side of the
transformer cover. The mounting hardware
for the battery shelf is taped to the battery
shelf. The mounting hardware for the
transformer cover is taped to the cover.
Follow these steps to route cables and
install the hardware:
1. Insert the connector for wire harness
J1 into the upper battery shelf so that
the leads hang down from the bottom
of the shelf.
2. Loosely screw the four screws provided
with each shelf into the four shelf
mounting holes. See
Figure 4
for
locations.
3. Route the cable connected to the
transformer up, and the battery cables
down through the notch at the back of
the upper battery shelf. All wire
connections to J1 stay below the
battery shelf.
4. Push the upper battery shelf back into
place and align the four holes in the
shelf with the screws. Slip the shelf
down over the screws. Do NOT tighten
the screws yet.
5. Install the bottom battery shelf by
loosely driving the screws into the
mounting flanges, slipping the shelf over the screws and
tightening the screws.
6. Replace the protective cover over the transformer while routing the battery cables
through the notch on the right side of the transformers enclosure cover. Make sure
the shrink wrapped circuit breaker is outside the notch so that it hangs over the
lower battery shelf.
7. Plug the transformer cable into J8 on the lower left-hand side of the D9142 Power
Supply.
8. Inspect the notch in the battery shelf to verify that the transformer and battery cables
route through and have not slipped outside of the notch as you tighten the screws on
the battery shelf.
9. Verify that the covers are securely installed over Fuse F1 and TB1, and that
connector P8 is plugged into J8 on the D9142 Power Supply.
✱
✱
✱
✱
✱
✱
✱
✱
✱
COMMUNICATOR
MOUNTING HINGES
MODULE CARRIER MOUNTING HINGES
BATTERY SHELF
MOUNTING FLANGES
BATTERY SHELF
MOUNTING FLANGES
ADDITIONAL MODULE
MOUNTING LOCATIONS
(USE D138 MOUNING BRACKETS)
TRANSFORMER
MOUNTING
LOCATION
EARTH GROUND STUD
MOUNTING FLANGE
MODULE CARRIER MOUNTING FLANGES
Figure 6: Mounting Locations