User Manual

mylifemyshop.com

Every Other Measurement

1. Make sure your scale is on a hard flat surface (not carpet) and has been

initialized.

2. The Body Analyzer 1 uses “Sense-On Technology” and automatic user

detection, so simply step onto the platform to take your measurement.

2. If you are taking a complete measurement, be sure to remove your shoes

and socks. You must have bare feet to obtain body fat and total body water

measurements.

• The condition of your skin on the bottom of your feet can affect the

reading. To get the most accurate and consistent reading, wipe your

feet with a damp cloth, leaving them slightly moist before stepping on

the scale.

3. Step onto the platform and ensure that your feet are in good contact with

the 4 stainless steel contact pads on the platform.

4. Stand still, and remain on your Body Analyzer 1 until the complete readout

is displayed.

5. Your weight will display followed by moving measurement indicators.

6. After 2-3 seconds, your weight will be joined by your body fat %, body

water %, muscle mass %, and bone density measurements.

7. You may step off of the scale; the measurements will continue to be

displayed for 10 seconds, after which time the scale will turn off.

Note:

When the body fat reading displays, a horizontal bar will appear below the

body fat reading. This corresponds to the Low, Normal, Moderate, and High

ranges.

TAKING A MEASUREMENT