Instruction manual

35
6. Maintenance
6-4 Cutting Depth Balance Adjustment
4
5
6
3
2
1
Knife
Up
Lock Bolt
Up
Balance Adjust Shaft Hole
Down
Left Adjustment Section Cover
Cutting depth balance adjustment is required
when cutting pressure is not the same in left
and right sides.
WARNING
- Handle knife with utmost care. Do
not touch knife.
CAUTION
- After adjusting cutting depth balance,
knife height adjustment is required in
some case.
1. Open left adjustment section cover.
2. Loosen lock bolt with allen wrench.
3. Insert allen wrench into balance adjust
shaft hole and adjust knife height.
NOTE
- The left side of knife rises/lowers by turning
balance adjust shaft.
4. Fasten lock bolt with allen wrench.
5. Close cover of adjustment section.
Down