Instruction manual

34
6. Maintenance
6-3 Knife Height Adjustment
6-3-1 Cutting Depth Adjustment
Knife Adjust Cover
Lock Nuts
Cutting depth must be adjusted after knife
replacement.
WARNING
- Operating PC-45 before cutting depth
is adjusted may cause some troubles.
1. Turn clamper hand wheel to lower pres-
sure.
2. Unplug power cord.
3. Open knife adjust cover.
NOTE
- Turn lock nut clockwise to loose lock nut.
4. Loosen two lock nuts of knife height
adjust screws with spanner.
5. Turn turnbuckle with adjust bar into adjust
screws hole to fit knife with the mark with
felt pen.
NOTE
- 1/6 turn of knife height adjust bolts raise/
lower knife about 0.6 mm. Excessive cutting
pressure does harm to PC-45. Maximum
cutting depth is 0.5 mm.
6. Fasten two locknuts.
7. Close knife adjust cover on the bottom.
Adjust Bar
Adjust Screw Hole
Spanner
Fasten
Loosen
Raise
Turnbuckle
Lower