Instruction manual

31
6. Maintenance
6-2 Knife Replacement
6-2-2 Knife Installation
POWER
CUTTER B
OFF
ON
Key Switch
4
5
6
3
2
Knife Securing holes
This section shows how to install knife.
WARNING
- Wear gloves when knife is replaced.
- Be careful of knife. Do not touch
knife directly.
- Knife may cause serious injury.
- Be careful of removed knife. Do not
put it on unstable place with knife bare.
NOTE
Sharpening Specifications
- Knife must be grounded to an angle of 20˚.
- Grind knife as little an necessary.
- Sharpened knife must have at least 65 mm
height. Replace knife whose height is less
than 65 mm with new one.
1. Turn off power with key switch.
2. Make sure all four knife securing holes
can be seen.