Instruction manual
29
6. Maintenance
6-2 Knife Replacement
4
5
6
3
2
1
Knife Securing Bolts
Knife Securing Bolts
4
5
6
3
Knife Holder
Cut Button A
Cut Button A
Key Switch
7. Turn on power with key switch.
8. Press cut buttons A and B to lower knife
until all four knife securing bolts appear.
NOTE
- Do not lower knife too low. Otherwise knife
cannot be removed.
9. Turn off power with key switch.
10.
Press the Standby button.
- Check that the Standby button lights.
11.
Open front cover.
12.
Remove the center two of four knife secur-
ing bolts with box wrench.
13.
Fasten knife holders enough.
WARNING
- Fastening knife holder insufficiently
may cause knife to fall and severe
injury to operators as a result. Do
fasten knife holder completely as
shown in the drawing below.
Knife
Knife Holder
Standby Button