Instruction manual

23
5. Troubleshooting
5-2 Cut Surface Has Diagonal Lines
Cut
Surface
Cut Sheets
5-3 Sheets Are Not Cut Equally
Clamper
Cutting Stick
Line
Knife
(Cause)
Knife is worn or nicked.
(Remedy)
Replace knife with new one referring to
"6-2 Knife Replacement".
Cutting Stick
Knife
Clamper
(Cause 1)
Clamper presses sheets too strongly or
knife moves forward slightly as knife
moves down.
(Remedy)
Weaken clamper pressure or replace knife
with new one.
(Cause 2)
Weak clamper pressure sometimes causes
bow-shaped section. Less than 20˚ angle
of knife sometimes also causes knife to
cut inward sheets.
(Remedy)
Tighten clamper or replace knife with
new one.