Instruction manual

14
3. Operation Procedure
4
5
6
3
2
1
3-1 Operation Procedure
0
1
2
9
8
7
Clamper Hand Wheel
Clamper
Scale
Back Gauge Handle
Back Gauge Dial
Key Switch
This section shows how to operate PC-45.
WARNING
- Do not put your hands under knife
while power is on.
- Assign only "ONE" operator to oper-
ate PC-45.
- It is dangerous to remain knife on
half position for fear of cutting hands
or fingers. Make sure to return knife to
home position.
CAUTION
- Cut only paper sheets. Otherwise PC-
45 may be broken.
1. Turn on power with key switch.
2. Press the Standby button.
- Check that the Standby button lights.
3. Turn clamper hand wheel counterclock-
wise to raise clamper.
4. Loosen the back gauge locking screw.
5. Adjust back gauge according to cutting
with back gauge handle.
NOTE
- Move back gauge from rear side to front
side. Otherwise, it errs in cutting width.
- Cutting line helps to see cutting position.
Cutting line is the beam that is reflected on
sheets.
6. Tighten the back gauge locking screw.
Standby Button
Back Gauge
Locking Screw