Instruction manual
33
Knife Lower Limit Adjustment Replacement and Adjustment
4-1 Knife Lower Limit Adjustment
The lowest position of the knife can be
adjusted mechanically.
Adjust the lower limit if the knife is worn
and the bottom sheet remains uncut.
Turn off the power switch.
Open the lower cover.
Loosen two lock nuts of knife height
adjusting screws using the wrench.
- The right lock nut is a left-handed screw.
4. Replacement and Adjustment
This chapter explains how to adjust the knife lower limit, the knife angle and
how to replace the cutting stick.
WARNING
• A single operator must perform the
adjustment.
• There will be some procedures to turn off
the power switch below. Make sure to turn
off the power switch. Otherwise, moving
parts can cause severe personal injury.
OFF
ON
Lower Cover
399 mm (15.71")
Lock Nuts
Wrench
Loosen