Instruction manual

32
3-8 Knife Replacement Message
When the cutting operation has been done
over 1,000 times since the last knife
replacement, the message shown at lower
right appears turning on the power switch.
This message informs you the knife
replacement timing. This message does
not mean that the knife must be replaced. If
the knife is still sharp enough to cut, you
can keep using the knife.
[If replacing the knife]
- Ask the replacement of the knife to your local
dealer.
[If not replacing the knife]
If not coming up this message until
the cutting operation has been
done over 1,000 times again
- Press the key.
- The machine comes up this message again after
another 1,000 times of cutting operation.
- The postponement of another 1,000 times can be
done repeatedly.
If indicating this message each
time the power switch is turned on
- Press the key.
C
En
t
Horizon APC-45
400.0mm
VX.XX
Turning on the power
switch...
7 8 9
C
4 5 6
1 2 3
-
Ent
0
=
+
Horizon APC-45
LOADING
. . .
REPLACE KNIFE
PRESS "Ent"
key
En
t
Message for
Knife
Replacement
key
C