Instruction manual

24
3-6 Creating a Cutting Program (Input)
Input the cutting length for the step 1.
- In this step, the cutting length of the step 1
should be 320.0 for example.
- Press the keys on the
numeric keypad. The backgauge moves to
the position of 320.0.
- Check that the current position of the back-
gauge is “320.0” and press the key
again.
- The step 1 is set and the step 2 is ready to be
input.
If the value after the decimal point is “0”,
the decimal point and “0” is not neces-
sary to be input.
Input the cutting length for the step 2.
- In this step, the cutting length of the step 2
should be 280.0 for example.
- Press the keys on the
numeric keypad. The backgauge moves to
the position of 280.0.
- Check that the current position of the back-
gauge is “280.0” and press the key
again. The step 3 is ready to be input.
Input the cutting length for the step
3 or after as well.
- In the following procedures, the last process
should be step 13 for example.
En
t
3 2 0
En
t
2:01:320.0
COURSE14 2 / 0
When the value for the
step 1 is input as 320, the
backgauge moves to the
position of 320.0.
When the key is
pressed again,
En
t
The value for
the step 2 is
ready to be
input.
En
t
2 8 0
En
t
2 / 0
2:01:320.0
COURSE14
3 / 0
3:02:280.0
COURSE14
2 / 0
2:280.01:320.0
COURSE14
The value for
the step 3 is
ready to be
input.
When the 280 is input in
the step 2,
The value for
the step 2 is
ready to be
input.
And when the key is
pressed again,
En
t
0
0
14
4
0
14
4
0
14
13 / 0
13:012:100.0
COURSE14
COURSE14
COURSE14
If the value for the step 3
or after is input,
appear.