Instruction manual

21
Function Cutting Operation Procedures
3-4 Function Cutting
Perform the cutting operation of the
step 1.
- Press both cutting buttons.
- When the step 1 is completed, the backgauge
moves to the position of the step 2.
- Press both cutting buttons at the
same time. If they are not pressed
within 0.5 seconds, the machine does
not operate.
- If your hand is released from one of
the cutting buttons while the knife is
lowering toward the lower limit, the
knife stops at that position.
- Release your hands from the cutting
buttons when the cutting operation is
completed. The secondary cutting
operation dose not start even if press-
ing them continuously after the cut-
ting process.
Perform the cutting operation of the
step 2.
- Place and align the sheets to the backgauge
and side guide.
- Check that the following message appears on
the guide window, and press both cutting but-
tons.
- When the step 2 is completed, the backgauge
moves to the position of the step 3. (If the
backgauge moves backward, it pushes out
the sheets first and moves backward.)
Repeat the cutting operation in the
same way.
Perform the cutting operation of the
last step.
- Place and align the sheets to the backgauge
and side guide.
- Check that the following message appears on
the guide window, and press both cutting but-
tons.
- When the step 3 is completed, the backgauge
moves to the position of the step 1.
3:295.02:296.0
M 3
2/3
Current Step
Guide Window
Next Step
3:295.0
M 3
3/3
Last Step
If nothing appears here, the
backgauge moves to the
position of the step 1.
Guide Window