Instruction manual
17
Cutting Operation by Programmed Value Operation Procedures
3-3 Cutting Operation by Programmed Value
This section explains the cutting operation
performed following the programmed pro-
cess.
When performing the same cutting process
repeatedly, or performing a complicated
cutting process, input each value of the
process in order beforehand, so that the
backgauge automatically moves into the
position for each step and makes the oper-
ation efficient.
Refer to “3-6 How to Program” for the pro-
graming and correcting the program.
Press the button.
- The LED on the upper left of the program but-
ton is illuminated and shows that the “cutting
operation by programmed value” is selected.
- The course number appears in the guide win-
dow.
Course Number:
“Course” is a program composed of a
series of the cutting steps. The course is
managed using the number 1 through 30.
Input the course number.
- Input using the numeric keypad.
- The value can be input in the range of 1 to 30.
Example:
When recalling the course number 3, press
the and keys.
The job name of the course number
should be written down when program-
ming.
To check the process of the course,
press the button.
- When the course number is input, the back-
gauge moves to the position of the step 1 and
the machine becomes ready to be operated.
WARNING
This machine must be operated by just one
person at a time.
CAUTION
Do not cut anything besides paper. This
may damage the machine.
SELECT COURSE
(
1-30
)
LED
1
Course number
can be input.
(“1” appears as
default value.)
3
En
t
2:280.0
1/3
COURSE
:
3
1:320.0
E13
:
NOT AVAILABLE
PRESS"Ent"
COURSE
:
20
NO MEMORY
This message appears
on the screen and the
backgauge moves to the
position of the step 1
(320.0).
When the course
number 3 is input,
This message
appears on the
screen.
When the incorrect course
number is input,
Press the key and input the
correct number again.
En
t
When the empty course
number is input,
appears.
To cancel the cutting operation by programmed
value, press the button.