Instruction manual

- 22 -
EBA 551-06 • EBA 551-06 LT
cm
inch
cm
inch
Working with programs
•
Press
p
©
P
appears on the display
•
1
...
9
Enter program number 1 ... 9.
With the button
r
and
h
you are able to
change between several program steps. With
S
the backgauge moves to the indicated
dimension. With
s
the backgauge stops.
General
LED "S" blinks © the basic position will
appear. LED "S" is off © the actual dimension
appears. In the program mode the ejection of
paper
r
is not possible. The ejection of
paper has to be programmed.
After each cut the backgauge advances to the
next dimension automatically.
Escape the program mode
•
Press
p
©
P
appears on the display.
•
Press
s
© escape the program mode.
Program buttons
h
and
r
programs
Button
h
= backgauge position rear
Button
r
= backgauge position front
Press
p
and simultaneously
h
(U appears
on the display) or Press
p
and
simultaneously
r
(D appears on the
display)
•
Enter the desired dimension (For example:
29,7 cm x 42 cm can be entered for DIN A3)
•
g
Store dimension.
Display in cm or inch
Press
i
© display changes between cm and
inch (see picture left). Measurements (in cm
or inches) for the rear reference point of the
backgauge are shown on the top of page 18.
•
Operation
•