Instruction manual

- 19 -
cm
inch
Eject function
If button
r O
is pressed instead of button
S Q
, after inserting the measurement, the
backgauge will advance forwards to
measurement 9 cm/3,54 inch (standard
setting of the machine) so that paper can be
removed. Finally the backgauge moves to the
last setting.
Adjust the eject-dimension
•
Press
p
, press
T
, Press
p
press
T
© e on display.
•
Insert the desired dimension.
•
g
Store dimension.
Multiple cut
•
Enter the multiple cut size on the display
S
.
•
Advance to the measurement with the
S
button.
•
Push the paper to the backgauge
I
.
•
Press
T
button © the red LED "M "
a
light
will be on.
•
Enter the multiple cut size.
•
After each cut the backgauge advances to
the next dimension automatically.
•
Pressing the
s
button
P
shows the actual
size.
Exiting program-mode
•
Press
T
button © LED "M "
a
is cleared
on the display.
Cutting activation
Warning!
•
Run backgauge to the front for turning the
paper stack.
•
Do not interrupt the upward movement of
the blade by performing switching
procedures.
•
Release blade only when LED "S" has gone
out.
•
Blade must always be at the top and be
covered by the clamp. Do not touch the
blade.
Risk of injury!
•
Operation
•