Instruction manual

- 18 -
EBA 551-06 • EBA 551-06 LT
cm
inch
cm
inch
Start machine
• Main switch
F
to position "I", Pull out blade
locking key
H
.
• Press
S
button
Q
© backgauge
I
moves
to the rear and searches for the reference
position, wait until a measurement is shown
in the display
D
(57 cm or 22,44 inches).
Warning!
Before storing or cutting a measurement
please check if the correct measurement
scale (cm or inch) see above is stored. For
information on how to store see picture
below left.
Cutting to specified dimensions
• Enter dimension on the numerical key pad
S
© LED "S"
Z
appears. (If a wrong
dimension is entered this can be corrected
by pressing the
s
button).
• Press
S
button © dimension is
approached, © LED "S" disappears.
Dimensions below 9 cm can only be
approached with the
S
button pressed and
held. (When the
S
button
Q
is released,
the backgauge
I
moves to a measurement
of 9 cm © measurement 9 cm appears,
keep the
S
button pressed, backgauge
I
moves to e.g. 7 cm).
• Insert paper and move by means of the
stacking angle to the backgauge
I
and side
lay on the left
J
.
• Release the cut.
Cut according to markings
• Adjust the backgauge with the
hand-wheel
G
to the back.
• Insert paper and move by means of the
stacking angle to the backgauge
I
and
side lay on the left
J
.
• Turn the hand-wheel
G
to the right until the
marking on the paper to be cut is below the
cutting line indicator.
• The further the hand-wheel
G
is turned to
the right, the quicker the backgauge moves.
If the hand-wheel is turned to the left the
backgauge will return quicker.
• Release the cut.
•
Operation
•