Service manual

3.0 Maintenance Guide
15
adjustment screw counter-clockwise. To set the knife to cut shallower, turn the screw
clockwise (Figure 12).
Figure 12
3. Note which side is not cutting completely through the paper. Lower the clamp to the table
with partially cut paper underneath.
4. Lower the clamp to the table. Remove the clamp handle, cutting lever handle, and top cover.
5. Slightly loosen the knife screws, keeping them somewhat snug.
6. Adjust the knife leveling screw (Figure 13) that corresponds with the side of the knife that
does not cut completely through. Re-tighten all screws and cut again. Continue adjustment
until sheets are cut completely through without great effort.
Figure 13
7. Tighten the knife bolts and reinstall the top cover, cutting lever handle, and clamp handle.
Knife Leveling Screws
Adjustment Screw