Service manual

3.0 Maintenance Guide
13
1/2 turn = .021” (7/32”)
2/3 turn = .028” (9/32”)
1 turn = .042” (13/32”)
Figure 9
5. Lay the machine flat, and connect power. Note: If power was not off, reset power, otherwise
the reading will be false. Bring the backgauge to the front to reset the display and make
another test. Repeat adjustment procedure if necessary.
3.4.3 Knife Bar Gib Adjustments
1. Make sure the knife is in up position and disconnect the power cord.
2. Lower the clamp to the table. Remove clamp handle, cut lever handle, and top cover.
3. Loosen the gib screw jam nuts on each side (Figure 10).
Preset
Screw