Service manual

3.0 Maintenance Guide
9
3.2.3 Machine Exterior
• The machine’s exterior should be cleaned with a non-abrasive water based detergent applied
to a damp cloth.
• Always be careful when cleaning around safety warning labels. Use limited amounts of
cleaners in those areas.
3.3 Lubrication
3.3.1 Clamp
Move the knife and clamp down. Disconnect the power cord and remove clamp handle, cutting lever
handle, and top cover. Wipe off any old or excess grease. Apply grease and oil to the areas shown
in Figure 2, Figure 3, and Figure 4 below.
Figure 2
Figure 3
Grease
Grease
Grease Leadscrew