Service manual

3.0 Maintenance Guide

Figure 15

4. Tighten screws, replace cover and clamp handle.

5. Test to make sure machine works properly, using the test found at the end of this manual.

3.4.9 Knife Up Limit Switch Adjustment

If the knife up limit switch becomes loose or needs adjustment, adjust as follows:

1. Turn off the power and disconnect the power cord.

2. With the top cover ON, place machine on a flat level surface on it’s left side and remove

bottom cover.

3. If the knife pull-down gear is disengaged, engage it now. See Section 3.4.12 Re-engaging

the Knife Pull-Down Gear, page 22.

4. Loosen bracket mounting screws (Figure 16, page 20), and slide bracket such that mounting

screws become located in the center of the slots. Then tighten screws, and check to make

sure screws mounting switch are tight also.

Note: Apply temporary thread lock to bracket mounting screws to prevent screws from

coming loose during operation.

Hinge Rod

Mounting

Screws