Service manual

3.0 Maintenance Guide

Figure 14

3. Place a white sheet of paper over the cut stick and turn the power on to activate the line light.

Note: 24V is being supplied to line light board while power is on.

4. Slide the line light assembly forward or backward to get a single, crisp line.

5. Tighten the screws and turn power off. Replace the cover and hand wheel.

3.4.8 Front Guard Switch Adjustment

The front guard interlock switch must be adjusted correctly in order for machine to function properly

and safely.

To adjust:

1. Turn off the power and disconnect the power cord.

2. Remove clamp handle and top cover.

3. Loosen (2) screws and nuts that mount the front guard switch as seen in Figure 15. Make

sure the front guard is lowered and slide the switch forward or backward until the actuator

lines up with the flat on the hinge rod (Figure 15). Leave a very slight gap (about the

thickness of a strip of paper) between the actuator and flat.

Line Light

Mounting

Screws