Service manual

3.0 Maintenance Guide
17
Figure 13
4. Make sure there is a slight gap between the front hand crank and the machine, slide collars
up tight against the nylon washers and tighten the collar screws.
5. Check to make sure the hand crank turns freely with no play.
6. Replace bottom cover and lay machine flat.
3.4.7 Line Light Adjustment
The line light can be adjusted if necessary as follows:
1. Remove the top clamp hand wheel and top cover.
2. Loosen the three line light mounting screws (Figure 14, page 18).
Leadscrew
Collars