Service manual

3.0 Maintenance Guide
15
6. Slightly loosen the remaining (5) knife screws, keeping them somewhat snug.
7. Adjust the knife leveling screw (Figure 11) that corresponds with the side of the knife which
does not cut all the way through. Tug on the paper while adjusting and stop when the bottom
sheet is cut all the way through.
Figure 11
8. Tighten the (5) accessible knife screws, replace top cover and clamp handle, restore power
to machine, raise up knife, and tighten (1) remaining knife screw.
3.4.5 Backgauge Gib Adjustments
If the backgauge does not stay square or moves up and down or back and forth when jogging paper
against it, the backgauge gib screws may be loose or worn.
To Adjust:
1. Turn off the power and disconnect the power cord.
2. With the top cover ON, place machine on a flat level surface on it’s left side and remove
bottom cover.
3. Loosen the two outside gib screw jam nuts (Figure 12, page 16).
Knife Leveling Screws