Service manual

3.0 Maintenance Guide
14
5. Replace top cover, plug in power cord, turn power on, and start a cut cycle.
6. When knife is all the way down, release right cut button only and switch off power.
7. Now with the knife in the down position, disconnect power cord, remove top cover, and
repeat gib screw adjustment for the BOTTOM GIB SCREW on each side.
8. Replace top cover and clamp handle.
3.4.4 Knife Leveling Adjustment
If knife cuts through one side of paper and not the other, the knife level may need adjustment. First
check to make sure the knife is all the way up in knife bar by looking through the viewing holes in the
knife bar (Figure 10). If it is not all the way up, loosen the knife screws and use knife lifter assembly
to raise knife up tight. Recheck knife by cutting through paper.
Figure 10
If knife is not cutting through paper evenly, use the following procedure to adjust:
1. Flip the cut stick to a new position and raise the knife depth by several turns of the screw
(see Operator’s Manual for more information on how to do this).
2. Place a few sheets of paper over the entire cut stick, and set the knife depth so that it just
cuts through the bottom sheet of paper on one side (see Operator’s Manual for more
information on how to do this).
3. Slightly loosen the left-most knife screw (but keep somewhat snug).
4. With the paper still in place, send the knife down by making a cut and continue to hold in the
left cut button while releasing the right cut button and turning off power. Disconnect power
cord.
5. Remove the clamp handle and top cover.
Viewing Holes