Service manual

3.0 Maintenance Guide
13
Figure 8
5. Replace bottom cover, lay machine flat, and turn on power. Note: If power was not off, reset
power now or else reading will be false. Bring the backgauge to the front to reset the display
and make another test. Repeat adjustment procedure if necessary.
3.4.3 Knife Bar Gib Adjustments
1. Make sure knife is in up position and turn off power and disconnect power cord.
2. Remove clamp hand wheel and top cover.
3. Loosen the gib screw jam nuts on the TOP TWO GIB SCREWS ONLY on each side (Figure
9).
Figure 9
4. Tighten gib screws so that screws are just snug then add a 1/8 turn. Hold screws in position
with tool then tighten jam nuts.
Preset
Screw
Top Two
Knife Bar
Gib Screws
Bottom
Knife Bar
Gib Screw
Top Two
Knife Bar
Gib Screws
Bottom
Knife Bar
Gib Screw