Data Sheet
Table Of Contents
- Abstract
- Version history
- 1. Product Introduction
- 2. Pins and dimension
- 3. Electrical Parameters
- 4. RF parameters
- 5. Antenna Information
- 6. Assembly Information and Production Guidance
- 7. Reference Circuit
- 8. FCC and IC Information
- 9. Module MOQ and Package Information
- 10. Sales Information and Technical Support
Datasheet [Page 8]
EMB1082
NO.
Name
Type
IO
Note
recommended to use as other function
17
SWD_IO
IO
GPIO8
FW programming, not recommended to use as
other function
18
SWD_CLK
IO
GPIO9
FW programming, not recommended to use as
other function
19
P0_1
IO
GPIO1
GPIO/PWM/I2C/SPI/UART, max drive current 8mA
20
P0_0
IO
GPIO0
GPIO/PWM/I2C/SPI/UART, max drive current 8mA
21
P0_5
IO
GPIO5
GPIO/PWM/I2C/SPI/UART, max drive current 8mA
⚫ Type S：power/ground，I/O: GPIO，A: Analog；
⚫ Both UART_TX/RX and SWD can be used for firmware programming. Pull down Debug
_TX and then power on the module to enter UART programming mode.
⚫ All the IO pins can be used as other functions.
⚫ SPI date rate: 5MHz
⚫ 400ksps, 12bit, AUXADC
⚫ The register setting of IO pins refer to below table: