Data Sheet
Table Of Contents
- Abstract
- Version history
- 1. Product Introduction
- 2. Pins and dimension
- 3. Electrical Parameters
- 4. RF parameters
- 5. Antenna Information
- 6. Assembly Information and Production Guidance
- 7. Reference Circuit
- 8. FCC and IC Information
- 9. Module MOQ and Package Information
- 10. Sales Information and Technical Support
Datasheet [Page 18]
EMB1082
⚫ In order to guarantee the reflow soldering qualification rate, vision and AOI detection should be done in
10% products for the first patch to make sure the rationality of temperature control, device adsorption mode
and position. Detect 5 to 10 sample every hour in the following batch production.
Considerations
⚫ Operator should wear anti-static gloves during producing;
⚫ No more than drying time;
⚫ Any explosive, flammable and corrosive material is not allowed to add in drying;
⚫ Module should be put into oven with high thermotolerant tray. Ventilation should exist between each
module and no direct contact with oven;
⚫ Make sure oven is closed when drying to prevent temperature leaking;
⚫ Reduce opening time or keep closing the door of the oven during drying;
⚫ Use anti-static glove to take out module when its temperature below 36℃ by natural cool down after
drying;
⚫ Make sure no water and dirt in the bottom of the module;
⚫ Temperature and humidity control is level 3 for initial modules. Storage and drying conditions are based
on IPC/JEDEC J-STD-020.