User manual

MX 30C+
MX C1, C2
MX C3+
24
Modification reserved
• 19, rue de Rennes • BP 83221 • F - 35690 ACIGNÉ
Lubricate every 10 hours and after each wash (water drives grease
out) and particularly after washing with a pressure washer.
See lubrication points opposite.
Every month, or more often with heavy use, check:
— The condition of the loader’s pivot points. As required, replace wear bushes and/or the pins.
Wear bushes must be replaced if they are less than 1 mm thick.
— The level of the tractor’s hydraulic oil and the sealing of the hydraulic circuit. If you find any internal or external leaks
on hydraulic components (rams, pipes, connectors, Mach, couplings, etc.), contact your dealer.
— The condition of the hoses: replace them if any cracks or oil seepages appear.
— The correct operation of the monolever (cables, play, locking, etc.).
— The condition of the electric cabling. Contact your dealer if any connectors or cables are damaged.
— The mechanical condition (any cracks, distortion, end stop matting, play, parking stands, etc.).
Contact your dealer if there is any abnormal wear.
Check the tightness of the bracket after 10 and 50 hours work, then every 100 hours or at each engine draining
of the tractor. If loose, please contact your dealer.
IMPORTANT:
Any fasteners/screws needing to be retightened must be inspected, replaced if necessary, cleaned and reassembled
using thread locking compound.
Tighten fasteners/screws in accordance with the tightening torque recommended in the table below.
(The use of an air gun to tighten the tractor’s bolts is prohibited)
Tightening torque (Nm)
Thread
Class of fastening
8.8 10.9 12.9
M 8 21 29 35
M 10 42 58 70
M 12 72 101 121
M 14 114 160 193
M 16 174 245 295
M 18 240 340 405
M 20 340 475 570
M 22 455 640 765
M 30 x 150 500
M 40 x 150 500