Quick Start Guide

Setup examples
English
5
Pairing
Needed when you have
more than 2 Remotes
Additional features
For the features below to work, the Receiver has to
be connected to a power source.
Pause/Play
Turn on/off
the Remotes
Turn on/off
the Receiver
Sleep Mode
Put the Remote you want to pair on the empty dock of your
choice on the Receiver and long press (3 sec.) the matching
Setup button. Your new Remote is paired with the Receiver
when its LED stops ashing.
Note: Each dock of the Receiver can only have one Remote
paired at the same time.
Press one time the Setup button to pause the matching Remote.
When the Remote is paused, the LED slightly fades.
Press the button again to reactivate the Remote.
To turn on a Remote, simply put it on one of the docks of your
Receiver. Your Receiver needs to be connected to a power
source.
Remotes automatically shut down after 10 minutes of Sleep
mode or 10 minutes after the Receiver has been unplugged.
Note: you can set the timeout before extinction from the
conguration software.
A paired Remote out of the Receiver automatically goes to
sleep mode after 10 minutes of immobility. Sleep mode lets you
save power when you’re not using Phase.
To wake your Remote from sleep mode, simply make it move.
Simply plug the Receiver to any USB power source (5V) to turn it
on, and unplug it to turn it off.
Phase with integrated
DVS mixer
Phase with
analog mixer
Integrated DVS mixer
Analog mixer
External DVS sound card
Computer
Computer
Phase Remote
Phase Remote
Phase Receiver
Phase Receiver
USB power cable
USB power cable
Line out
Line out
Line in
Line in
1
1
2
2
3
3
4
4
5
5
6
7
6
7
8
7
8
5
5
6
4
4
2
2
1
1
6
7
3
3
1
1
4