User guide

Unicorn Information System

1. Install the USB wireless LAN card provided to USB host. When installation is recognized, a single beep is produced.

2. In Mvixbox, login with sysadmin account. Then, select network setting menu.

3. Select 'Wireless' in wired/ wireless setup to

display wireless setup at the bottom.

4. Enter ESSID of wired/ wireless IP Router (or

AP) to be connected to ESSID

If the wired/ wireless IP Router (or AP)

is applied with security setup, make input with

the same setup.

(Caution. Capital/ small letters are distinguished

and accurate input is necessary. If not, wireless

connection is not possible.)

Note. Using of DHCP (automatic IP address) is

optional. When IP of Mvixbox is changed, set IP

with the same network as sharer, etc.

if it is difficult to check the IP change.

Manufacturer Model Chipset

UNICORN TW-54G

RT2571

D-LINK DWA-110

IP-TIME G054U-2

ANYGATE XM-152

Note. USB wireless LAN card provided per manufacturer

Contents of the above table are on LAN card that uses Ralink 2571 chip driver.

Chip sets/ model names to be added can be checked in http://www.mvix.net or http://www.eunicorn.co.kr.

C. Using USB wireless LAN card

Appendix.