User guide

Unicorn Information System

1. In Wire/ Wireless Setup, select either wire or wireless

for network connection method.

2. In Automatic Addressing (DHCP), select either used

or unused. When used is selected, IP address, net

mask, gateway and DNS setup below are inactivated.

To designate IP manually, select unused and

accurately enter IP address, net mask and gateway.

3. In DNS Setup, enter DNS server address.

4. When wire was selected, select Save to save the

contents of setup.

5. When wireless has selected, enter additional

wireless-related information.

a. In ESSID, enter SSID of wireless AP or wired/

wireless sharer to be connected.

b. Set Channel as default [Auto]. In case connection

fails, change wired/ wireless sharer or AP channel.

c. Select Security mode. There are ‘Non’, ‘WEP Auto’,

‘WEB Open’, ‘ WEP Shared’, and ‘WPAPSK” mode.

Select one of them refer to the Network setting of the

Wireless AP.

d. In WEP Key Setup, enter the same key as the WEP

key set in wired/ wireless sharer or AP. Accurately

enter the WEP key in terms of digits and by

distinguishing between capital and lower-case letters.

e. If you choose the ‘WPAPSK Mode’, Select either

AES or TKIP for WPA Password. It must be the

same set in wired/wireless sharer or AP.

f. In WPA Key Setup, enter the same key as the WPA

key set in wired/ wireless sharer or AP. Accurately

enter the WPA key in terms of digits and by

distinguishing between capital and lower-case letters.

6. Select Save to save the set values.

2.5.1 Network Setup

2.5 Network Management

Chapter 2. Administrator