Operation Manual

Menu Operations
27
After modification select “OK” of button bar and press [OK] on the RCU to rename the favorite
group name and leave the edit mode. Press [Exit] on the RCU to exit the edit mode without saving
the favorite group name.
3.3.9 Other
In “Other” menu;
1. LNB Power: If your receiver is connected to the LNB directly then you need to set the LNB
Power to “On”. If your receiver is connected to a multi switch (SMATV signal distribution
system) then it may be that you don’t need to provide the power to the LNB. But since this is
depending on the kind of installed distribution system we recommend you to contact your
installer or to refer to the user manual of this system to get the correct information.
You also just can change this setting and check if you still can receive the channels. If the
LNB Power is off and you still can see all channels then we recommend this setting.
2. Channel Play Type: Press [Vol◄/►] to switch this function All, Free and Scambled.
3. Beeper: Press [Vol◄/►] to switch this function On or Off